Discussion:
OSX 10.9.5 & RUMtrol7k-RT Connectivity
(too old to reply)
Keith Kaiser wa0tjt-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org [linuxham]
2014-09-24 19:51:58 UTC
Permalink
Raw Message
I can not connect to my 7000 from RUMtrol7k-RT v2.1. I can connect just fine from RUMlog and from all my other digital apps (fldigi, WSJT-x).
I'm using CI-V so my port is usbserial, I have Baud set to 9600 and none of the boxes checked. However I've obviously tried each one at a time and in combination. Usually the port says something like tty.usbserial but here it says usbserial only. Could this be part of the issue?
I don't get an error, it just doesn't read or write to the XCVR.

Has anyone successfully used RUMtrol with this version of the OSX?

Thanks in advance everyone.
Barry Porter BarryP13-ee4meeAH724@public.gmane.org [linuxham]
2014-09-24 20:01:31 UTC
Permalink
Raw Message
Fldigi claims it is damaged and does not work.

Barry, kb1pa
Post by Keith Kaiser wa0tjt-***@public.gmane.org [linuxham]
I can not connect to my 7000 from RUMtrol7k-RT v2.1. I can connect just fine from RUMlog and from all my other digital apps (fldigi, WSJT-x).
I'm using CI-V so my port is usbserial, I have Baud set to 9600 and none of the boxes checked. However I've obviously tried each one at a time and in combination. Usually the port says something like tty.usbserial but here it says usbserial only. Could this be part of the issue?
I don't get an error, it just doesn't read or write to the XCVR.
Has anyone successfully used RUMtrol with this version of the OSX?
Thanks in advance everyone.
Loading...